Configuring The Digital Telephone For The Correct Number Of Line Keys; Figure 7-27 Installing The Line Key Panel; Table 7-6 Numbered Keypad Type - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
7 - 28
8. Install the supplied Line Key Panel (refer to
the Line Key
9. Install the side panel.
10. Connect the line cord/LAN cable and the AC/DC adapter to the
DTL/ITL multiline terminal.
4.5.2

Configuring the Digital Telephone for the Correct Number of Line Keys

1. With the telephone not plugged in and the handset on-hook,
press the 4 and 6 buttons on the numbered keypad and connect
the telephone cable.
This places the telephone into Service Class R/W mode. The Message
Waiting LED should be lit.
2. Press 1 to enter the Line Key Type mode.
The Message Waiting LED should flash.
3. Follow the directions below for the type of line key module
installed:

Table 7-6 Numbered Keypad Type

Numbered Keypad Type
2-Button
6-Button
8-Button
12-Button
24-Button
Installing DT300/DT700 Series (DTL/ITL) Digital and IP Multiline Terminals
UNIVERGE SV8100/SV8300
Panel).

Figure 7-27 Installing the Line Key Panel

Push
Figure 7-27 Installing
Line Key
Panel
1
2
3
4
5