System Requirements And Specifications; Cabling; Figure 2-3 Connecting The Dlc Using Twisted 2-Pair Cable; Table 2-12 Dt300 Series Loop Resistance And Cable Length - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
S
S 6
YSTEM
ECTION
6.1
2 - 16
R
EQUIREMENTS AND

Cabling

This section provides cabling requirements and specifications for various
equipment used in the SV8100 system.

Figure 2-3 Connecting the DLC Using Twisted 2-Pair Cable

chassis connected with each of the multiline terminals and single line
telephones by a separate twisted 1-pair cable or 2-pair cable (only for multiline
terminals).
DLC
Figure 2-3 Connecting the DLC Using Twisted 2-Pair Cable
Refer to the following tables for cabling requirements and specifications.

Table 2-12 DT300 Series Loop Resistance and Cable Length

Table 2-13 DT700 Series Loop Resistance and Cable Length

term
Table 2-14 D
Length
Table 2-15 Cable Connection Between the Analog Port and the Single
Line Equipment

Table 2-16 Cabling Requirements

Table 2-12 DT300 Series Loop Resistance and Cable Length
Terminal or Adapter
DTL-2E-1( ) (BK) TEL
DTL-6DE-1( ) (BK) TEL
DTL-8LD-1( ) (BK) TEL
DTL-24BT-1( ) (BK) TEL
DTL-24PA-1( ) (BK) TEL
DTL-24D-1( ) (BK) TEL
DTL-32D-1( ) (BK) TEL
DCL-60-1( ) Console
An AC Adapter is required.
S
PECIFICATIONS
Twisted 2-Pair Cable
term
Series i or D IP Terminal Loop Resistance and Cable
By Twisted 1-Pair Cable
(without AC Adapter)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
1,969 ft (600m)
UNIVERGE SV8100/SV8300
is a diagram of the
RJ-11
Multiline Terminal
24 AWG
SV8100 System Specifications