UNIVERGE SV8100/SV8300
System Hardware Manual
ANALOG PORT
Set the dip switches on the APR adapter to the required position.
12.4.2
Installing the APR-L( ) UNIT
Perform the following to connect the APR-L( ) UNIT to the Bottom
Option Interface located underneath the DTL multiline terminal.
Only one APR-L( ) UNIT can be installed.
1.
Unplug the line cord from the multiline terminal.
2.
Turn the DTL multiline terminal upside down.
3.
Lower the tilt leg to the first position (refer to
Separate Tilt Leg from Leg
4.
Push the two stopper tabs through the slots to separate the tilt
leg from the leg support.
5.
Lay the tilt leg and the leg support flat to expose APR-L( ) UNIT
compartment.
Figure 10-54 APR-L( ) UNIT
To prevent possible damage to the APR-L( )
UNIT or the DTL multiline terminal during
installation or removal, disconnect the line
cord cable and the AC/DC adapter from the
DTL multiline terminal.
Support).
Tilt Leg
Figure 10-55 Separate Tilt Leg from Leg Support
Issue No. 1.5
1 ~ 5, 7, 8 = Off
6 = On
Figure 10-55
Stoppers
10 - 65