Issue No. 1.5
10 - 4
4.
Strip one end of the cable to be connected to the control relay or door
box so that approximately 1/4" (8 mm) of bare wire is exposed.
5.
Insert the cable into the proper CN4 or CN5 location while holding down
the lock button (holding down this lock button is easiest with a flat-head
screwdriver). Once the cable is in place, release the lock button.
Refer to the specific function being connected for more detail on PGD(2)-U( )
ADP connections.
Figure 10-4 PGD(2)-U( ) ADP Jumper Settings
Installing SV8100/SV8300 Optional Equipment
UNIVERGE SV8100/SV8300