Figure 10-8 Installing The Screws - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
10 - 8
In some cases, when testing the operation of an
extension port when connecting to a Cordless II,
Cordless Lite II, or PGD(2)-U( ) ADP, a technician
may connect a line cord directly from an extension
port on the CD-8DLCA/CD-16DLCA Blade. Though
this is not the recommended connection, it can be
used to test these devices.
Should a direct connection of this type be made to the
base station of the Cordless II or Cordless Lite II, or
to a PGD(2)-U( ) ADP, the line cord must be 2-wire
(1-pair). If a 2-pair wire is used, the system provides
power to the unused pair. This can prevent the
cordless telephone from acquiring a link with the
base station or it can damage the PGD(2)-U( ) ADP
or the SV8100 station card.
The recommended connection is to punch down 2
wires to the cross-connect block, then connect the
extension block to the RJ-61 connector on the Blade.
13. Optional:
To wall mount the PGD(2)-U( ) ADP, insert two wood screws 100mm
apart (3 15/16"). Leave 3mm (1/8") of the screw exposed. The screws can
be installed either vertical or horizontal, depending on which position fits
best for your location.

Figure 10-8 Installing the Screws

Installing SV8100/SV8300 Optional Equipment
UNIVERGE SV8100/SV8300