Using The Psa-L( ) Adapter; Figure 10-71 Install Plastic Panels - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
10 - 74
23. Reinstall both plastic panels to the front of the multiline terminal
(refer to
24. Connect the line cord to the adapter.
25. Connect the user system (KTS or PBX) cable.
26. If required, remove the side panel from the original cradle unit.
12.5.2

Using the PSA-L( ) Adapter

1. Placing Calls:
When the PSTN line is activated either manually by the switch or
due to a power failure, use the dial pad buttons (0-9, *, #) to
place an outside call. Use the Vol
decrease audio levels.
Other than receiving calls, no other multiline terminal
functions are available.
2. Answering Calls:
If you receive a call via PSTN during a conversation via
LAN, answer the call by completing the LAN call and
placing the handset back into the cradle. Change the LAN/
PSTN Change Switch to PSTN and then lift the handset to
answer the call. If you change the LAN/PSTN Change
Switch to the PSTN position while talking via LAN, the LAN
call is disconnected.
Other than receiving calls, no other terminal functions are
available.
Figure 10-71 Install Plastic Panels on page

Figure 10-71 Install Plastic Panels

CAUTION: Before installing or removing the
PSA-L( ) adapter, remove the line cord, LAN
cable, and then AC adapter from the outlet.
Installing SV8100/SV8300 Optional Equipment
UNIVERGE SV8100/SV8300
10-74).
or to increase or