Installation - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
3.4.2

Installation

To install a PZ-VM21 on the CD-CP00-AU or CC-CP00:
1. Included with the PZ-VM21 are four plastic spacers. Install the
plastic spacers on the PZ-VM21. Make sure to attach the
spacers so that they extend out on the side of the daughter
board which has the CN1 connector. Refer to
Installing the PZ-VM21 on page
2. For installation on the CD-CP00-AU blade refer to
CD-CP00-AU Blade with Daughter Boards Installed on
page 6-14. For installation on the CC-CP00 blade, refer to
Figure 6-6 CC-CP00 Blade on page
3. Position the PZ-VM21 CN1 connector over the CN4 connector
on the CD-CP00-AU
the plastic spacers lock in place.
4. Insert the CompactFlash card into the CN2 slot.
The LED1 status lights steadily when a card is installed.
Do not remove or install the CD-CP00-AU or
CC-CP00 with the power on.
. Press the boards together, ensuring
blade
Issue No. 1.5
Figure 6-9
6-36.
Figure 6-4
6-22.
6 - 35