Installation - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
6 - 72
Connection point for CD-LTA
These trunk circuits wired as T-Bus (SV8100) or S-Bus (SV8300 only)
can be connected to ISDN trunks or ISDN telephones, depending on
the switch setting in system programming. All ISDN telephone circuits
[#1-2 (BRI blade) and #3-4 (with the BRI daughter board)] are
supplied DC power from the UNIVERGE SV8100/SV8300 system.
System programming must be used to block new calls on the blade.
This program prevents new calls from being established on the blade,
but it will not terminate any existing call.
Refer to the following table for maximum upgrade capacities of the
PZ-2BRIA
blade:
Table 2-4 SV8100 Maximum System Capacities – Blades on
page 2-7
5.4.2

Installation

To install the PZ-2BRIA on the CD-2BRIA:
Attach the PZ-2BRIA daughter board to the CD-2BRIA blade by lining up the
CN5 connectors and pressing the boards together. (Refer to
Installing the PZ-2BRIA Daughter Board on page
1. Install the CD-2BRIA blade into the system chassis.
2. Before proceeding to Step 3, wait to verify that the STATUS LED
starts to flash.
3. Connect the cable from the NT1 Network Termination cable to
the CN7 or CN8 connector on the CD-2BRIA and/or PZ-2BRIA
daughter board.
UNIVERGE SV8100/SV8300
With normal operation, the status LED
flashes fast. If trouble was found during
the self diagnostics routine, the status
LED flashes slow.
Once connected, the PKG LED will not
be indicated for the status of Layer 1
Link.
Installing the SV8100/SV8300 Blades
Figure 6-24
6-71.)