Installation - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
HDLC Packet Processing
Real Time Clock (tolerance 30 seconds/month)
Internal MOH Generation (supplied from Melody IC)
Call Control Server (ex: Voice Mail Server, SIP Server, RTP
Forwarding, VoCoder Conversion)
One Connector for PAL EPROM
One lithium battery (Sony CR2032 or equivalent) which provides
battery back-up of system data and RAM memory for
approximately 30 months
The CC-CP00 functions provided are:
Call Control Server
Voice Mail Server (voice mail requires a compact flash card)
SIP Server
RTP Forwarding
VoCoder Conversion
3.2.2

Installation

Each SV8300 system must have the CC-CP00 installed in the
Controlling Chassis.
The power to the chassis must be off when installing or
removing the CC-CP00.
After removing a previously installed CPU handle the
blade, carefully, from the edges. If certain solder points/
resistors are touched on the back of the blade, some
RAM/temporary memory may be lost (e.g., time, date,
user-defined settings, etc.)
1. Remove the CC-CP00 and install the VMDB, MEMDB or
VOIPDB daughter board, if required.
2. Ensure the power supply is OFF, then slide the CPU in the
CCPU slot in the Controlling Chassis.
3. When the second CPU blade is installed in the Expansion
Chassis, the system automatically assigns the primary and
secondary designation. The CPU installed first is assigned as
the primary.
IMPORTANT INSTALLATION NOTES
Issue No. 1.5
6 - 25