Installing The Ct(A)-R( ) Unit; Figure 12-20 Connecting A Multiline Terminal To A Pc Using A Ct(A)-R( ) Unit (Example) - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
Figure 12-20 Connecting a Multiline Terminal to a PC using a CT(A)-R( ) Unit
(Example) shows how the CT(A)-R( ) Unit is connected to the ESI(8)-U( ) ETU
and to the PC. The required AC-2R/AC-3R Unit adapter is not shown.
Multiline Terminal + CT(A)-R( ) Unit
ESI
ETU
Line Cord (2-line)

Figure 12-20 Connecting a Multiline Terminal to a PC using a CT(A)-R( ) Unit (Example)

3.4.1

Installing the CT(A)-R( ) Unit

The CT(A)-R( ) Unit should be installed before connecting the PC and
before connecting the ESI port to the multiline terminal.
When wall mounting the Multiline Terminal, a WM-R( ) Unit must be used.
Refer to
1. Prepare multiline terminal for adapter installation. Refer to
Section 2 Preparing Multiline Terminal for Adapter Installation on
page
CT(A)-R( ) Unit
Optional Headset
Section 11 Wall Mounting Multiline Terminals on page
12-1.
RS-232C Cable (Straight)
[CT(A)-R( ) Unit: D-sub9 Male Pin]
Issue No. 1.5
PC
11-16.
12 - 15