Figure 5-36 Rack Mount Bracket Installed 19" Chs2U-Au Chassis; Figure 5-37 Rack Mount 19" Chs1U-Au And Chs2U-Au Chassis - NEC UNIVERGE SV8100 System Hardware Manual

Issue No. 1.5
Single CHS1U-AU Rack Mount
with One CHS2U-AU Expansion
5 - 32

Figure 5-36 Rack Mount Bracket Installed 19" CHS2U-AU Chassis

4. Carefully slide the chassis into desired location within the rack. Make
sure the hooks on the mounting bracket are inserted into the back of the
chassis, securing it in place. Note that the cabling is run through the front
of the rack for ease of access.
5. Secure the brackets to the rack using the screws supplied.
Repeat for additional chassis mounting.

Figure 5-37 Rack Mount 19" CHS1U-AU and CHS2U-AU Chassis

6. Connect the ground wire to all chassis. Refer to
Grounding on page 5-45
7. Refer to 3.5 Installing the 19" Chassis on page 5-33
installation of the chassis or, Chapter 5 paragraph
Extension or Trunk Blade on page 6-3
CHS1U-AU
Each chassis will require approximately 1.75" of
height within the rack.
CHS2U-AU
Each chassis will require approximately 3.5" of
height within the rack.
Single CHS1U-AU Rack Mount
with Three CHS2U-AU Expansion
for complete details on grounding the system.
UNIVERGE SV8100/SV8300
3.5.7 Install 19" Chassis
to continue
2.2 Installing an
for installation of blades.
Installing the SV8300 Chassis