Table 12-2 Ad(A)-R( ) Unit Switch Settings - NEC UNIVERGE SV8100 System Hardware Manual

UNIVERGE SV8100/SV8300
System Hardware Manual
To provide control to the recorder or to enable/disable the record start
warning tones, refer to
Switch
SW1
SW2
Dip
Switches
(DSW)
Do not connect T1 and T2 when DSW switches 3 and 4 are On.
3.2.3 Installing the AD(A)-R( ) Unit on a Multiline Terminal
The AD(A)-R( ) Unit should be installed after the cables are
connected and the switches are set.
If wall mounting the Multiline Terminal, a WM-R( ) Unit must be used. Refer
to Section 11 Wall Mounting Multiline Terminals on page
1. Unplug the telephone cord (and the AC-2R/AC-3R Unit cord if
installed) from the multiline terminal.
Table 12-2 AD(A)-R( ) Unit Switch

Table 12-2 AD(A)-R( ) Unit Switch Settings

SW1-1 Connects to multiline terminal
Connect = Default
SW1-2 Not Used
SW2-1
Sets External Equipment Impedance to 600
SW2-2 Used for Complex Impedance Devices
Ω
(< 30 Input Impedance)
DSW 1 Output Hook Signal to External Device
On = Output
Off = No Output (Default)
DSW 2 Record Confirmation Tone
On = Tone On
Off = Tone Off (Default)
DSW 3 Use T1/T2
and On = Disable (Default)
DSW 4 Off = Enable
DSW 5 Reset Signal Upgrade
On = Normal (Default)
Off = Debugging
DSW 6~8 Firmware Upgrade
On = Firmware Upgrade
Off = Disable (Default)
Issue No. 1.5
Settings.
Description/Settings
11-16.
Ω
12 - 9