Mitsubishi Electric MELDAS 600M Series Instruction Manual page 104

2.6.4 Changing the display mode
The graphics display mode includes one plane, two plane or solid displays. By pressing the menu key
corresponding to each plane's axis configuration, the screen changes. The system also changes.
The axes corresponding to X, Y and Z are set with operation parameters.
Parameters
(Note) When the display mode is changed, the graphics displayed up to that point are erased.
(1) Menus used for changing the display mode
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
$1 $2
X X1 X2 ............ Axis for each system corresponding to X
Y Y1 Y2 ............ Axis for each system corresponding to Y
Z Z1 Z2............. Axis for each system corresponding to Z
Menu
This changes to the one plane display mode
XY
configured of X-Y.
This changes to the one plane display mode
YZ
configured of Y-Z.
This changes to the one plane display mode
XZ
configured of Z-X.
This changed the display mode to that displaying the
XY/XZ
two planes X-Y and X-Z or Y-X and Z-X.
This changed the display mode to that displaying the
YX/YZ
two planes Y-X and Y-Z or X-Y and Z-Y.
This changes to the three-dimensional display mode.
XYZ
A cube is displayed on the lower right of the screen.
search engine
2. Monitor (Operation) Screens
Details
I – 89
Type Reference
C –
C –
C –
C –
C –
C –