Mitsubishi Electric MELDAS 600M Series Instruction Manual page 308

5.8.1 Setting the channel of the waveform to be displayed
5.8.2 Carrying out continuous sampling
When the menu key Continu samplng is pressed, the sampling will start and the waveform will be
displayed continuously. When the menu key is pressed again, the menu highlight will return to normal,
and the sampling will stop.
(1) Carrying out continuous sampling
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1)
Press the menu key
Display mode .
2)
Input a value.
1/3/9 INPUT
1)
Press the menu key
To cond set to display the
V Anlyz condition screen.
Then, set the conditions and
data.
Refer to section "5.7.1
Setting the condition data" for
details.
2)
Press the menu key
Display mode , and set the
channel of the waveform to
be displayed.
Refer to "5.8.1 Setting the
channel of the waveform to
be displayed" for details.
3)
Press the menu key
Continu samplng .
search engine
5. Diagnosis Screens
The cursor will appear at the display mode field.
"1/3/9" will appear at the cursor position.
The channels in the sampling data display field will
change to the 1, 3 and 9 channels.
The channel 1, 3 and 9 data will be sampled.
The V Anlyz condition screen will open.
After setting the conditions or data, press the menu
key To V-Anlyz to display the Visual analyzer
screen.
The sampling and waveform display will start.
I – 293