Changing The Display Axis - Mitsubishi Electric MELDAS 600M Series Instruction Manual

(2) Basic operation methods

2.1.4 Changing the display axis

If many axes are being used and all axes cannot be displayed on the counter at once, the menu key
Next axis
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
1)
Display the current position
counter in the counter display
area.
2)
Press the menu key
.
Counter set
Instead of pressing
, the axis name
Counter set
address key can be pressed
to set the counter.
Z 1
(Example)
3)
Input a numeric value.
100.000
INPUT
4)
Repeat step 3) for each axis.
When the counter for the final axis has been set, the Counter set mode is canceled. The mode
can also be quit by pressing the other menu key or by pressing the
again.
(Note 1) To set a value for an axis that is not displayed, press the menu key
display the target axis, or input the address name of that axis.
(Note 2) For axes that are not to be operated, press the
(Note 3) When setting or canceling the origin, carry out the following operations instead of
steps 2) and 3) in the operation above.
To set the origin ........... Press the menu key
To cancel the origin ...... Press the menu key
can be pressed to change the displayed axes and display the remaining axes.
search engine
The cursor appears at the No. 1 axis of the current
position counter.
Curnt posn
X1 123.435 #1
Y1 62.735
Z1 804.017 #1
Curnt posn
X1 123.435#1
Y1 62.735 #1
804.017#1
Z1
V1 180.203
W1 272.076
INPUT
"100.000" appears at the cursor position.
Curnt posn
X1 100.000 #1
Y1 62.735 #1
Z1 804.017
V1 180.203
W1 272.076
I – 32
The cursor appears at the 1st axis.
#1
The cursor appears at the designated
axis.
#1
#1
The set value appears at the cursor
position. The cursor moves to the next
#1
axis.
#1
#1
Counter set
key and move the cursor.
↓
and
Origin set
and
Origin cancel
menu key
to
Next axis
.
INPUT
.
INPUT