Replacing Character Strings - Mitsubishi Electric MELDAS 600M Series Instruction Manual

4.2.8 Replacing character strings

A character string in a program can be searched for and replaced.
The following two methods can be used.
• The corresponding character string is searched for and replaced one by one. (To search for the next
character string, press the
• All corresponding character strings in the program are replaced in a batch. (Add "/G" when setting.)
(1) Operation method
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
INPUT
1)
Press the menu key
String replace .
2)
Designate the character to be
searched for and the
replacement character string.
(Note 1) (Note 2)
Search character string/
replacement character
string INPUT
3)
To continue search/
replacement, press the
key again.
INPUT
4)
To end search/replace, press
the menu key String replace
(Note 1) When batch replacing all in the program, add "/G" to the above setting.
Search character string/replacement character string/G
During batch replacement, after replacing all character strings to the end of the
program, the process ends while showing the last character string replaced. Note
that the replacement mode is held, and the character string remains in the data
setting area.
(Note 2) If the program character strings from the current cursor position to the last line are
to be replaced in a batch, add "/E" to the above setting.
search engine
4. Edit Screens
key.)
The menu is highlighted.
The character string is searched downward from the
character string after the current cursor position.
When the character string is found, it is replaced with
the set character string. The program is displayed with
that character string line at the head.
The cursor moves to the head of the replaced character
string.
If the character string is not found in the program, the
cursor does not move.
The corresponding character string is searched for.
When the end of the program is reached, a message
will appear.
When using batch replacement, the replacement is
already completed, so the process is not carried out.
The menu highlight returns to normal, and the
character string in the data setting area disappears.
.
The replacement mode is held until the menu key is
pressed.
(The character string remains in the setting area.)
I – 251
INPUT