Screen Operations; Setting A Manual Value Command (S, M, T, B) - Mitsubishi Electric MELDAS 600M Series Instruction Manual

1.5 Screen operations

1.5.1 Setting a manual value command (S, M, T, B)

The spindle function S, miscellaneous function M, tool function T and 2nd miscellaneous function B
commands can be set with screen operations. This carries out the S, M, T, B command execution
program by commanding the operations with key inputs on the screen.
(1) Screens in which manual value commands can be set
(Target commands that can be set are shown in parentheses.)
• Position display1 screen, Position display2 screen
• Tool measure screen, Tool registration screen
• Coord offset screen, Workpiece measure screen, Rotate measure screen (M, T)
• Pallet prog regist screen
(Note 1) Manual value commands can be issued with address inputs on the Position display1
(Note 2) Issue the commands for the 2nd spindle and following on the Position display2 screen.
(2) Conditions for manual value commands
• The manual value command option must be valid.
• S, M, T or B command must not be in execution.
(3) Operation methods (When executing T31 with a manual value command)
(Note 1)
(Note 2)
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1. Operating the Setting and Display Unit
screen and Position display2 screen.
1)
Select the menu
Manual value .
2)
Using the , keys, move
↑ ↓
the cursor to the position to be
(Note 1)
set.
3)
Set the numeric value, and press
(Note 2)
the INPUT key.
31 INPUT
On the position display 1 and 2 screens, by inputting an address key such as S , M
or T instead of steps 1) and 2), the cursor appears at the corresponding display
position.
To set a negative value, add a " − " in front of the numeric value.
Refer to "(4) Manual value command setting and output range".
When using a BCD output type or unsigned binary output type, a value converted into a
positive value is set.
search engine
The manual value command mode is entered.
The cursor appears, and the menu is highlighted.
The command value executed last is displayed on the
screen.
S 100
M 50
T 3
B 1000
The cursor moves.
S 100
M 50
T 3
B 1000
The command is executed.
The menu highlight is removed, and the cursor
disappears.
I – 12
(S, M, T, B)
(M, T)
(S, M, T, B)