Mitsubishi Electric MELDAS 600M Series Instruction Manual page 199

(5) Setting the tool life data
(6) Copying/pasting the tool life data
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1)
Move the cursor to the data to
be set.
(Note) One of the following methods can be used to move to the target data.
• Using the cursor movement keys
be set.
2)
Input the value.
20 INPUT
(Note 1) The other settings will be invalid when the tool ST (status) setting data are not set.
(Note 2) The same tool cannot be set in more than one group.
(Note 3) If the tool No. is not set, the other data cannot be set.
1)
Move the cursor to the line to
be copied.
2)
Press the menu key
Line copy , and then press
the INPUT key.
3)
Move the cursor to the line
where the data is to be
pasted.
4)
Press the menu key
.
Line paste
(Note) Once copied, an item of data is held until a new data item is copied.
search engine
3. Setup Screens
←
↓ ↑
, , and
The set value appears.
The menu is highlighted.
The entire copy target line is highlighted.
The copied data is written in the line where the cursor
is.
I – 184
→
, move the cursor to the line to