Mitsubishi Electric MELDAS 600M Series Instruction Manual page 479

Error No.
PR0063
PR0070
PR0071
PR0072
PR0073
PR0080
PR0090
PR0093
PR0100
PR0101
PR0110
Downloaded from ManualsNet.com
CHAPTER 4 APPENDICES
Appendix 3. Alarm Messages
Message
The high speed mode command
No high speed mode
has been issued even though
spec.
there are no specifications.
There is an error in the arc start
Arc end point
and end points as well as in the
deviation large
arc center.
The arc center is not calculated
Can't calculate arc
during R-specified circular
center
interpolation.
A helical command was issued
No heircal spec.
even though there are no helical
specifications.
Three axes were commanded for
the arc command.
A spiral command was issued
No scroll spec.
despite the fact that such a
command does not exist in the
specifications.
A hypothetical axis command
No hypothetic axis
(G07) was issued despite the fact
spec.
that such a command does not
exist in the specifications.
A thread cutting command was
No thread cutting
issued despite the fact that such a
spec.
command does not exist in the
specifications.
The thread lead (thread pitch) is
Screw pitch err
incorrect.
Cylindrical interpolation was
No cylinder
commanded even though there
interpolation spec.
are no cylindrical interpolation
specifications.
A command not permitted with the
Cylinder mode error
cylindrical mode was issued.
A plane selection command (G17,
Plane selected
G18, G19) has been issued in a
during pattn rot
pattern rotation command.
search engine
Details
• Check the specifications.
• Check the numerical values of
the addresses that specify the
start and end points as well as
the arc center in the program.
• Check the "+" and "−" directions
of the address numerical
values.
• Check the numerical values of
the addresses in the program.
Check the specifications.
• If this is not a helical command,
move the linear axes command
to the next block.
• The G02.1 and G03.1
commands are issued for
circular interpolation.
• Check the spiral specifications.
• Check the hypothetical axis
specifications.
• Change the G07 command.
• Check the specifications.
• Correctly set the thread lead.
• Check the specifications.
• Reconsider the machining
program.
• Delete the plane selection
command (G17, G18, G19)
from the pattern rotation
subprogram.
IV – 37
Remedy