Transmitting Diagnosis Data To The Machine Manufacturer; Canceling Network Service Warnings; Message Displays - Mitsubishi Electric MELDAS 600M Series Instruction Manual

5.11.1 Transmitting diagnosis data to the machine manufacturer

5.11.2 Canceling network service warnings

(Note 1) A warning message will appear if an error occurs when reception of the diagnosis

5.11.3 Message displays

Messages indicating the net communication state, etc., are displayed on the MTB net screen.
"∗∗∗" is displayed at the end of the message to indicate the transmission/reception status during
transmission/reception of files.
(Note 1) The asterisks increase by one each time the operation progresses. Up to five asterisks
(1) Messages related to all MTB net screens
(None)
(2) Messages related to transmission of diagnosis data
Transmit diagnosis
data? (Y/N)
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1)
Press the menu key Send .
2)
Press "Y" or the
key.
1)
Press the menu key
Warning cancel .
results is completed or during communication.
will be displayed.
Message Display in message field
Press the Send menu to transmit
the diagnosis data to the machine
manufacturer. Do not turn the power
OFF during transmission.
Message Display in message field
Press "Y" to transmit the diagnosis
data, and "N" to cancel the process.
When the line is busy, the
connection will be established after
the line becomes idle.
search engine
5. Diagnosis Screens
The menu will be highlighted, and the message
"Transmit diagnosis data? (Y/N)" will appear.
Messages indicating the status will appear in
INPUT
sequence, and a connection to the NC service will be
established.
("Connecting" → "Waiting for the reply" →
"Connecting" →"Transmitting" → "Connecting")
After establishing a connection, the diagnosis data is
transmitted to the machine manufacturer. The menu
highlight is turned OFF after the diagnosis data has
been transmitted, and messages from the machine
manufacturer will appear.
The network service warning message will be erased
and canceled.
I – 304
Details
• Communication is not established.
Details
• The system is not connected with
the machine manufacturer.
• The system is checking whether
to actually send the diagnosis data
to the machine manufacturer.