Mitsubishi Electric MELDAS 600M Series Instruction Manual page 96

(6) Drawing during the check
During the check, the machine position (tool center) path is drawn. However, if a radius
compensation is applied on the program during the check, the program path and tool center are
drawn.
The lines displayed during the check are expressed as follows.
Manual feed
Rapid traverse
Cutting feed
(7) Availability of check mode with other functions
Note that some commands and button operations in the program, etc., cannot be used with the
program check.
Coordinate rotation
Pattern rotation
Decimal point
programming
Mirror image
Z-axis command cancel
Interlock
External deceleration
Override
Feed hold
Cycle start
Auto-restart
Work coordinate offset
Local coordinate offset
Verify stop
Helical interpolation
Fixed cycle and special
Fixed cycle
Manual mode/handle
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
Program move path
Tool center move path
Program move path
Tool center move path
Program
Function name
check
search engine
During radius
compensation
−
Solid line (White)
Solid line (Blue)
Solid line (White)
Solid line (Green)
Remarks
Available with either program coordinate rotation or
parameter coordinate rotation.
Available with either Type I or Type II.
See item (9).
A move path is drawn exactly as specified.
If CYCLE START is pressed during checking, alarm
message "PROG. CHECK MODE" is displayed while it is
held down.
CHECK COMPLETE occurs with M02/M30.
Set to the position determined by the actually specified
offset amount.
Set to the position determined by the actually specified
offset amount.
The system does not stop operation even when it
executes the set stop block.
Drawn in straight lines.
During checking, the machine can be moved by
switching the mode to manual handle mode. This
disables checking, however.
I – 81
Not during radius
compensation
−
−
Solid line (Blue)
−
Solid line (Green)