Mitsubishi Electric MELDAS 600M Series Instruction Manual page 142

3.3.1 Selecting a device, directory and file
This section explains the methods of designating the device, directory and file name of the target file for
operations such as file transfer and erasing carried out on this screen.
(1) File selection sequence
Designate the device where the target file exists
Designate the directory with full path
Designate the file name
(2) Menus used
Device menu submenus
RS232C
∗ The list of recommended IC cards is given below.
ATA flash
IC card
(Note 1) Only the FAT16 format IC card can be used. If a FAT32 format IC card is used, it will be
(Note 2) An IC card with a capacity of up to 2GB can be used.
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
↓
↓
Menu
Memory
This selects the memory.
This selects the RS-232C (including tape)
This selects the HD (hard disk).
HD
(Note) This menu is indicated as Data server for
the MELDAS610M, 630M and 650M.
This selects the IC card.
IC card
Use a recommended IC card that matches the
Mitsubishi quality standards. (Refer to ∗ for details)
Ethrnet
This selects Ethernet.
FLD
This selects the FLD.
Item Maker
SDP3B-6-101-B4
SDP3B-20-101-B4
SANDISK
SDP3B-40-101-B4
SDP3B-85-101-B4
recognized as non-formatted, and an error will occur.
search engine
3. Setup Screens
→ Select from the submenu.
→ Key input the full path, or select
from the list
→ Key input the file name, or select
from the list
Details
Type Specifications
6MB
20MB
40MB
85MB
I – 127
Type Reference
C –
C –
C –
C –
C –
C –
Remarks
Recommended part
101-B4 given in
the type on the
Recommended part
left may be
Recommended part
omitted from the
type when sold.
Recommended part