Tool Registration Screen - Mitsubishi Electric MELDAS 600M Series Instruction Manual

3.10 Tool Registration screen

In this screen, a tool No. is assigned to each tool to make the tools installed on the machine recognizable
to the NC. The tool No. is registered corresponding to the magazine pot and spindle where that tool is
installed, and the standby location.
When the tool No. and magazine pot are changed by a tool selection command or tool replacement
command, the new tool No. is displayed.
The number of tool registrations differs depending on the specification configuration. A maximum of 120
tools can be registered. Tool Nos. can have up to eight digits.
The usage of this screen differs depending on the user PLC. Refer to the instruction manual issued by
the machine manufacturer for details.
1. Magazine
No.
2. Tool No.-D
3. Ladder
usage range
(1) Display items
1. Magazine No.
2. Tool No.-D
3. Ladder usage range
4. Manual value setting
5. PLC command
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Display item
This displays the currently selected magazine No.
This displays the tool No. (Refer to the instruction manual issued by the
manufacturer for D data functions and targets.)
If the number display is blank, the tool is probably not installed or does not
match the spindle.
Check the tool. If "0" is input, the tool registration is erased.
(The name of this area differs depending on the output from the ladder.)
This displays each command value of M (miscellaneous function
command value) and T (tool command value).
Data can be transferred from the screen on the ladder side, and
sequence processing carried out by the user PLC.
search engine
3. Setup Screens
Details
I – 203
4. Manual value
setting
5. PLC command