Mitsubishi Electric MELDAS 600M Series Instruction Manual page 226

(3) Registering a machining program for the pallet
(4) Precautions
• Only decimal (1 to 99999999) programs can be registered.
In addition to the NC memory, the HD, FLD and IC card programs can be registered. However,
these programs must be in the root directory.
• Up to two pallets can be registered.
• Regardless of whether the program is running, an error message may appear depending on the
PLC device value.
• The auxiliary setting range is –32768 to 32767.
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
1)
Using the , and tab
↑ ↓
keys, move the cursor to the
area of the pallet for which a
program is to be registered.
2)
Press the menu key
Device select , and select
the device.
3)
Move the cursor to the
"Program NO." position, and
input the program No.
100 INPUT
4)
Move the cursor to the
"Machining ON/OFF"
position, and press the menu
key ON or OFF .
5)
Move the cursor to the
"Program Search ON/OFF"
position, and press the menu
key ON or OFF .
6)
Move the cursor to the
"Program Start ON/OFF"
position, and press the menu
key ON or OFF .
search engine
3. Setup Screens
The cursor will move between the Program field,
Machining field, Aux. field, Program Search field and
Program Start field for each pallet.
The selected device name will appear at "Program
Dev.".
The set details will appear at "Program NO.".
The set details will appear at "Machining".
The set details will appear at "Program Search".
The set details will appear at "Program Start".
I – 211