Mitsubishi Electric MELDAS 600M Series Instruction Manual page 303

(2) Setting the servo ax data
Data related to the servo axis, such as the Posn command, Droop and FB posn, and the data
related to the auxiliary axis are set with the following procedure.
As an example, the position command data for X2 axis will be set.
(3) Setting the spindle data
The data related to the spindle, such as the spindle droop and motor rotation speed is set with the
following procedure.
As an example, the motor rotation speed for 2nd spindle will be registered.
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Setting format
Axis name
1)
Move the cursor to the "Data"
position, and press the menu
key Posn command .
2)
Input the axis name.
X2 INPUT .
(Note) Data related to the auxiliary axis is set in the same manner.
Setting format
Spindle name S + No. (No. can be omitted for 1st spindle)
1)
Move the cursor to the "Data"
position, and press the menu
key Motor speed .
2)
Input the spindle name.
S2 INPUT
(Note) For 1st spindle, "1" can be omitted, and only "S" set.
If the spindle No. is omitted, 1st spindle will be set as the default.
search engine
5. Diagnosis Screens
The details set in "Data" will appear.
Ch2
Data
V-scale/div
Base line
Offset
Samp valid
The details set in "Data" will appear.
Ch2
Data
V-scale/div
Base line
Offset
Samp valid
I – 288
Setting example
X, X2, etc.
X2/Position command
10000
0
0
0
Setting example
S, S2, etc.
S2/Motor speed
10000
0
0
0