Mitsubishi Electric MELDAS 600M Series Instruction Manual page 476

3.5 Operation errors (OP
No.
OP0101
OP0102
OP0103
OP0104
OP0105
OP0106
OP0107
OP0108
OP0109
OP0110
OP0111
OP0114
Downloaded from ManualsNet.com
Appendix 3. Alarm Messages
Message
Stroke end axis The automatic operation paused
exists because an axis exists that is at
its stroke end.
Stored stroke The automatic operation paused
limit axis exists because an axis exists that has
reached its stored stroke limit.
No. of spindle rot The spindle rotation speed
times over exceeded the clamp speed of the
axis when the thread cutting
command was issued.
Verification error An axis exists in which a
axis exists verification error in the verification
of the reference point return.
In axis control Operation is not possible because
an axis exists that is already being
controlled.
Emergency stop Operation is not possible because
an emergency stop has occurred.
Program running A program check, etc., was
attempted during operation.
Program A program operation, restart
checking search or machining time
calculation was attempted during
a program check.
No option spec An operation not provided in the
specifications was attempted.
Invalid Research The block immediately after the
after NURBS NURBS interpolation mode was
designated as the restart position,
and the program was restarted.
No NB number An NB number not available was
designated for the search.
Restart from The program was restarted from
PRG TOP invalid the head.
search engine
CHAPTER 4 APPENDICES
)
Details
IV – 34
Remedy
• After resetting, cancel the stroke
end by a manual operation.
• After resetting, cancel the stored
stroke limit by a manual
operation.
• Decrease the spindle command
rotation speed.
• Reconsider the program.
• Restart after stopping the
operation.
• Restart after canceling the
emergency stop.
• Carry out program checks after
finishing the operation.
• Carry out the operation again
after the program check is
completed or after resetting.
• Check the specifications.
• Designate a block other than the
block immediately after the
NURBS mode as the restart
position.
• Check the NB number.
• Search may not be possible in the
NURBS interpolation mode.
• To restart the operation from the
program head, press cycle start.