Mitsubishi Electric MELDAS 600M Series Instruction Manual page 461

(3) Messages related to operator notification
Operator notice
effective
Dialing
Connecting
Sending
(None)
Waiting for dialing
(Status of
communication with
NC service)
(Status of
communication with
machine
manufacturer)
(4) Messages related to one-touch call
Carry out one-touch
call? (Y/N)
Dialing
Connecting
Sending
Downloaded from ManualsNet.com
Appendix 2. Operation Messages
Message Display in message field
If automatic operation stops while
operator notification is valid, the
designated telephone number will
be contacted.
Do not turn the power OFF until the
operator notification ends.
Do not turn the power OFF until the
operator notification ends.
Do not turn the power OFF until the
operator notification ends.
Press Call to call the NC service.
Do not turn the power OFF during
the one-touch call.
Do not turn the power OFF until the
operator notification ends.
Connecting with NC service.
Wait for communication to end.
Connecting with machine
manufacturer.
Wait for communication to end.
Message Display in message field
Press "Y" to make a one-touch call,
and press "N" to cancel.
If the line is being, a connection with
NC service will be established as
soon as the line is idle.
Do not turn the power OFF until the
one-touch call is completed.
Do not turn the power OFF until the
one-touch call is completed.
Do not turn the power OFF until the
one-touch call is completed.
search engine
CHAPTER 4 APPENDICES
IV – 19
Details
• Operator notification is valid.
• If machining ends normally or
abnormally in this state,
communication with operator
notification will start.
• Data is being transmitted with
operator notification.
• Communication will start when
machining ends normally or
abnormally, but the line is not
connected yet in this state.
• This state is also entered when
standing by for transmission.
• The line is connected with
operator notification.
• The diagnosis data is being sent
with operator notification.
• Communication with operator
notification has ended, and the
line has been disconnected.
• Redialing since the NC service is
using the line for other
communication.
• In connection standby state since
line is being used by anshin-net.
• In connection standby state since
line is being used by machine
network.
Details
• A connection with NC service has
not been established.
• The system is confirming whether
to actually make a one-touch call.
• Data is being transmitted with
one-touch call.
• Communication will start when "Y"
is pressed in step 1, but the line is
not connected yet in this state.
• The line is connected with
one-touch call.
• The diagnosis data is being sent
with one-touch call.