Mitsubishi Electric MELDAS 600M Series Instruction Manual page 497

No.
SYW0060
SYW0070
SYW0071
SYW0072
SYW0073
SYW0074
SYW0999
Downloaded from ManualsNet.com
CHAPTER 4 APPENDICES
Appendix 4. Warning Messages
Message
PLC-H timer over The PLC high-speed process
exceeded the allocated time.
Receive result of The diagnosis data file has
diagnosis been received.
Modem initial When the modem was
error connected after power ON, an
error was found in the modem
and communication could not
be established.
Redial over Dialing failed, and the number
of redials was exceeded.
No dial tone When dialing, the phone line
was not connected with an
analog modem.
Network error An error other than SYW0070 to
SYW0073 occurred during
communication.
The tool No. was registered in
Tool double
registration duplicate.
search engine
Details
• Shorten the high-speed process.
• Erase the message.
• Connect the model and turn the
power ON again.
• Check the number of redials
setting.
• Connect the phone line.
• Check the cause.
• Change the tool No.
IV – 55
Remedy