Mitsubishi Electric MELDAS 600M Series Instruction Manual page 120

2.10.3 Control parameter 2 details
The control parameters for each system are displayed and set on this screen.
For parameters indicated with a "∗" in the table, turn the NC power OFF after setting. The setting is
validated after the power is turned ON again.
#
320001 G00 dry run
320002 Macro single
320003 Middle point
320004 Machine lock
320005 G04 time fixed
320006
320007 Decimal point
(Note) If the control parameter "#320033 Tcomp interf chk OFF" is set to "OFF", the "#320006 Rad
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
Item Setting
ON
OFF
ON
OFF
ON
ignore
OFF
ON
rapid
OFF
ON
OFF
Rad compen ON
intrf byp
(Note)
OFF
ON
type 2
OFF
compen intrf byp" setting is invalid. Even if the workpiece is cut into, an alarm is not
generated. Machining proceeds without changing the path.
search engine
The external manual feedrate is enabled in respect to rapid
traverse (G0, G27, G28, G29, G30, G60).
The "rapid traverse rate × rapid traverse override value" set in
the machine parameters is applied.
The macro block is handled as one block. The single block
operation can be stopped at each macro block.
The macro block is not handled as one block. The program is
processed at a high speed.
During G28, G30 reference point return command, the middle
point designated in the program is ignored, and the axis returns
directly to the reference point.
During G28, G30, the program designation is followed, and the
axis returns to the reference point via the middle point.
When carrying out automatic operation in the machine lock
state, the feedrate becomes the machine lock speed. The
machine lock speed is set with the machine parameter's Base
system param "120072 M_lock rapid feed".
During machine lock, the feedrate is the commanded speed,
and is the same process time as normal automatic operation.
The G04 command is a time designation in both the
synchronous feed mode (G95) and asynchronous feed mode
(G94).
The G04 command is a time designation in the asynchronous
feed mode (G94), and a rotation designation in the
synchronous feed mode (G95).
During the radius compensation interference check, the path is
changed so that the workpiece is not cut into by the tool radius.
During the radius compensation interference check, if the block
is determined to cause cutting into the workpiece by the tool
radius, an alarm is generated before execution, and the
operation stops.
1 of a position command data without a decimal point
command is controlled as 1mm (1 inch).
1 of a position command data without a decimal point
command is controlled as the min. input command unit
(0.01mm, 0.001mm or 0.0001mm) designated in the
specifications.
I – 105
Details