Mitsubishi Electric MELDAS 600M Series Instruction Manual page 350

5. Operation Panel Switches in Operation Mode
5.1 Rapid traverse override
Use the RAPID TRAVERSE OVERRIDE switch to
override the rapid traverse feedrate in automatic or
manual operation.
RAPID TRAVERSE OVERRIDE is applicable to the
following:
5.2 Cutting feed override
Use the FEEDRATE OVERRIDE switch to override
the feedrate in automatic operation (G01, G02, or
G03F command) or the manual feedrate of jog feed
in manual operation in 10% units in the range of 0%
to 300%. FEEDRATE OVERRIDE is also applicable
to the dry run rate in automatic operation.
(Note 1) The dry run rate is the movement rate set by using the MANUAL FEEDRATE switch by
(Note 2) See Section 6.7 for feedrate override applied to manual feedrate.
5.3 Manual feedrate
Use the MANUAL FEEDRATE switch to set the feedrate in jog feed mode during manual operation.
The feedrate can be selected among 31 steps from 0 to 14000.0 mm/min.
When the MANUAL OVERRIDE switch (interrupt switch) is turned ON, the override value set by
using the FEEDRATE OVERRIDE switch takes precedence over the value set by using the
MANUAL FEEDRATE switch.
Downloaded from ManualsNet.com
CHAPTER 2 MACHINE OPERATIONS
5. Operation Panel Switches in Operation Mode
Automatic operation: G00, G27, G28, G29, G30
Manual operation: Rapid traverse, return to
reference point,
incremental feed
overriding the programmed feedrate in automatic operation.
Manual feedrate (mm/min)
0. 7.2 72
1.0 10.0 100
1.4 14.0 140
2.0 20.0 200
2.7 27.0 270
3.7 37.0 370
5.2 52.0 520
search engine
720 7200
1000 10000
1400 14000
2000
2700
3700
5200
II – 17
FEED RATE
OVERRIDE
100
50
25
1
%
CUTTING FEED OVERRIDE
MANUAL FEEDRATE
37.0
27.0
mm/min.