Mitsubishi Electric MELDAS 600M Series Instruction Manual page 420

6.4 Stored stroke limit IC
(1) To share the setting range designation with soft limit IB and IC
Stored stroke limit IC is valid when the axis specification parameter "130027" is set to "2", and
cannot be used with soft limit IB.
The boundary is set for each axis with the parameters (axis parameters "340025 OT_IB–" and
"340026 OT_IB+". The inside of the set boundary becomes the additional moveable range.
(2) To independently designate the setting range with soft limit IB and IC
This is valid when the axis specification axis parameter "130027 IB_off" is set to "0" or "1", and
"130062 IC_off" is set to "0".
The boundary is set for each axis with the parameters (axis specification parameters "130060
OT_IC–" and "130061 OT_IC+". The inside of the set boundary becomes the additional moveable
range.
Downloaded from ManualsNet.com
6. Setting the Stored Stroke Limit
Machine coordinate system
Machine moveable range
Point 1
Point 3
search engine
CHAPTER 3 MAINTENANCE
Point 2
Point 1
Additional
moveable
range
III – 34
The following values are set with the
coordinate values in the machine
coordinate system:
Point 3: 130025 OT_IB– or
130060 OT_IC–
Point 4: 130026 OT_IB+ or
130061 OT_IC+
The area determined by points 1
and 2 is the prohibited range set
with stored stroke limit I.