Mitsubishi Electric MELDAS 600M Series Instruction Manual page 447

G86 (O100000860) Boring 2
N5 M5 ;
N1 M99%
G87 (O100000870) Back boring
N1 M99%
Downloaded from ManualsNet.com
Appendix 1. Fixed cycle Programs
G. 1 ;
IF [#30] GOTO1 ;
G0 Z#2 G#6 H#7 ;
#2 = ##5
#3003 = #8 OR 1 ;
G1 Z#3 ;
IF [#4 EQ #0] GOTO5 ;
G4 P#4 ;
G0 Z−#3−#2 ;
#3003 = #8 ;
M3 ;
G. 1 ;
IF [#30] GOTO1 ;
#3003 = #8 OR 1 ;
#26 = #30064+#30074 ;
#28 = #12∗COS[#26]+#13∗SIN[#26] ;
#29 = #13∗COS[#26]−#12∗SIN[#26] ;
M19 ;
X#28 Y#29 ;
#3003 = #8 ;
G0 Z#2 G#6 H#7 ;
#3003 = #8 OR 1 ;
G1 X−#28 Y−#29 ;
#3003 = #8 ;
M3 ;
#3003 = #8 OR 1 ;
Z#3 ;
M19 ;
G0 X#28 Y#29 ;
Z−#2−#3 ;
#3003 = #8 ;
X−#28 Y−#29 ;
M3 ;
search engine
CHAPTER 4 APPENDICES
Fixed cycle block 1 movement command
Check for Fixed cycle invalidity.
Inhibit single block stop.
Dwell.
Stop the spindle.
Return.
Rotate the spindle forward.
Fixed cycle block 1 movement command
Check for Fixed cycle invalidity.
Inhibit single block stop.
Orient the spindle.
Cancel single block stop inhibition.
Inhibit single block stop.
Cancel single block stop inhibition.
Rotate the spindle forward.
Inhibit single block stop.
Orient the spindle.
Shift.
G87 is not affected by the G98 or G99 modal.
Cancel single block stop inhibition.
Shift.
Rotate the spindle forward.
IV – 5