Mitsubishi Electric MELDAS 600M Series Instruction Manual page 371

6.18.4 Axis movement speed resulting from interruption
(1) The movement speed of the axis for which handle interruption is executed, may exceed the
(2) When cutting feed commands (G01, G02, G03) are issued during automatic start, the
(3) If, during automatic start, manual handle interruption is executed, in the same direction, for the
(4) If an attempt is made to execute interruption at a speed exceeding the clamp speed, the reading
(5) The handle scale factor depends on the selected input of the manual handle/step scale factor.
Downloaded from ManualsNet.com
CHAPTER 2 MACHINE OPERATIONS
6. Operation Switch Functions and Other Functions
rapid traverse feed rate during rapid traverse feed command (G00) processing in automatic
start. To prevent this, clamp the axis. (The movement speed equals Automatic-start movement
speed + Speed resulting from manual handle interruption.)
movement speed of the axis for which the handle interruption is executed is clamped so it will
not exceed the rapid traverse rate of that axis. The movement speed equals the Automatic
movement speed + Interruption speed by the manual handle. (The movement speed equals
Automatic start movement speed + Speed resulting from manual handle interruption.)
axis that is moving at an external decelerating speed, the axis movement speed may exceed
the external decelerating speed. To prevent this, clamp the axis. (The movement speed equals
Automatic start movement speed + Speed resulting from manual handle interruption.)
on the handle scale does not match the distance of interruption.
search engine
II – 38