Mitsubishi Electric MELDAS 600M Series Instruction Manual page 458

2.11 Editing-related operation messages
File open error
Designated file does not
exist
Designated file already
exists
Can't write in
READ-ONLY file
Paste position is illegal
Copy range is
inadequate
Area designation is
inadequate
Designated line is out of
program range
Designated character
string not found
Save current file? (Y/N)
Designated file does not
exist
MDI search complete
MDI search error
Save left side file? (Y/N) • Message to confirm the operation when saving files.
Save right side file?
(Y/N)
Editing
No. of program entry
over
Edit lock B
Edit lock C
MDI no setting
Abs/Inc mode is illegal
Replace ? (Y/N)
Downloaded from ManualsNet.com
Appendix 2. Operation Messages
Message
• The designated file is already open.
• A file that does not exist was designated when file editing.
• When creating a new file, a file name was designated that already
exists.
• The file designated for writing is write-protected.
• Pasting was attempted within the copy range of the same file.
• The copy range designation is inadequate.
→ Check whether the designated range exists.
• The area designation is inadequate.
→ Check whether the designated area exists.
• Designation was attempted of a line No. larger than the No. of lines in
the entire program.
• Could not find the search results and character string in the program.
• Message to confirm the operation.
[Y] : Save the changes to the current file.
[N] : Do not save the changes to the current file.
• Designation and editing was attempted of a file that does not exist.
• The MDI search completed.
• Could not execute the MDI search.
[Y] : Save the file on the left side.
[N] : Do not save the file on the left side.
• Message to confirm the operation when saving files.
[Y] : Save the file on the right side.
[N] : Do not save the file on the right side.
• A program is being edited on the screen.
→ Save the program to write it into the memory.
• The program could not be registered in the memory when attempted,
because the No. of registrations would be exceeded.
• Execution was attempted of an operation (edit, play back, input/output,
etc.) that is prohibited for machining program B (8000 to 8999:
standard user subprogram).
• Execution was attempted of an operation (edit, play back, input/output,
etc.) that is prohibited for machining program C (9000 to 9999:
machine manufacturer custom program).
• Editing of the MDI was started, but the MDI setting was incomplete.
• During playback editing:
G90 was set when control parameter "Playback G90" was OFF.
G91 was set when control parameter "Playback G90" was ON.
• Message to confirm the character string replacement.
[Y] or [INPUT] : Replace the character string.
[N]
search engine
CHAPTER 4 APPENDICES
: Do not replace the character string.
IV – 16
Details