Mitsubishi Electric MELDAS 600M Series Instruction Manual page 367

(3) Operation when automatic operation commands and manual/automatic simultaneous valid
selection are issued for same axis
(a) If a movement command with automatic operation is issued to a manual/automatic
(b) If the "manual/automatic simultaneous valid" signal is turned ON for an axis moving with
Downloaded from ManualsNet.com
CHAPTER 2 MACHINE OPERATIONS
6. Operation Switch Functions and Other Functions
simultaneous valid axis, the operation warning "OPW0105 Internal interlock axis exists" will
occur. Automatic operation will stop in the interlock state until the "manual/automatic
simultaneous valid" signal turns OFF. The manual/automatic simultaneous valid axis can be
controlled in the manual operation mode during this time.
Program operation mode (Y708)
(memory mode)
Automatic operation start (Y710)
Automatic operation block progress
Jog mode (Y700)
Manual/automatic simultaneous
valid Z axis (Y522)
Feed axis selection + Z axis (Y4E2)
Axis moving signal + Z axis (X3A2)
automatic operation, the operation warning "OPW0105 Internal interlock axis exists" will occur,
and the operation will decelerate to a stop immediately. Automatic operation will stop in the
interlock state until the "manual/automatic simultaneous valid" signal turns OFF. The manual/
automatic simultaneous valid axis can be controlled in the manual operation mode during this
time.
Note that the interlock will be applied even during a tap modal.
Interlock will also be applied during synchronous tap cutting, and the spindle will also be
synchronized to the manual drilling axis.
search engine
"OPW0105 Internal interlock axis exists"
G91 G00 X100. Y100. ;
Movement with jog feed
II – 34
G91 G00 Z100. ;
Movement with
automatic operation