Mitsubishi Electric MELDAS 600M Series Instruction Manual page 229

3.11.3 Pallet details screen
The program No., machining validity and external workpiece coordinates, etc., for each pallet plane are
set on this screen.
(Note 1) This screen appears when the base common parameter APC type (#110141) is set to 1.
1. Pallet Program
No., Dev.
2. Machining
ON/OFF
3. External
workpiece
coordinates
(1) Display items
1. Program No., Dev.
2. Machining ON/OFF
3. Ext coord
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Display item
The machining program No. and device registered for each index plane of
each pallet are displayed.
Set whether machining is valid for each index plane of each pallet.
This data cannot be set if the machining ON/OFF screen setting is set to
OFF (when R903 is set to 1). The cursor will not move to this item in this
case.
Set the external workpiece coordinates of each index plane of each pallet.
The set data (X to Z axes, B axis) is set in the expanded workpiece
coordinate offset corresponding to the pallet No. and index plane.
X to Z axes : External workpiece coordinate data
B axis
Example) Pallet 1 0°
The value set as the external workpiece coordinate is written into the
external workpiece coordinate shift (EXT) according to the commands
from the PLC.
If the external workpiece coordinates for the machining plane of the pallet
in the machine are updated, only the data of the changed axis will be
written into the external workpiece coordinate shift (EXT).
The data can also be input into the external workpiece coordinates from
the program using the programmable data input (G10). Note that the
values set with programmable data input will not be reflected onto the
screen.
search engine
3. Setup Screens
Details
: Index angle shift amount (0, 90, 180, 270)
: Expanded workpiece coordinate offset set 49
Pallet 1 90° : Expanded workpiece coordinate offset set 50
Pallet 1 180° : Expanded workpiece coordinate offset set 51
Pallet 1 270° : Expanded workpiece coordinate offset set 52
Pallet 2 0° : Expanded workpiece coordinate offset set 53
Pallet 12 270° : Expanded workpiece coordinate offset set 96
I – 214
4. Device Name,
file list
7. Machining
indication
5. M, S, T, B
command
6. Program being
executed
: