Message Displays - Mitsubishi Electric MELDAS 600M Series Instruction Manual

5.9.5 Message displays

Messages that indicate the anshin-net connection status, etc., are displayed on the Anshin-net
message screen.
A message also appears if a communication error occurs during the anshin-net connection.
"∗∗∗" is displayed at the end of the message to indicate the transmission/reception status during
transmission/reception of files.
(Note 1) The asterisks increase by one each time the operation progresses.
(1) Messages related to all Anshin-net screens
(None)
(2) Messages related to automatic alarm notification
Dialing
Connecting
Sending
(None)
Waiting for dialing
(Status of
communication with
NC service)
(Status of
communication with
machine
manufacturer)
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
Up to five asterisks will be displayed.
Message Display in message field
Press Call to call the NC service.
Do not turn the power OFF during
the one-touch call.
Message Display in message field
Do not turn the power OFF until the
automatic alarm notification ends.
Do not turn the power OFF until the
automatic alarm notification ends.
Do not turn the power OFF until the
automatic alarm notification ends.
Press Call to call the NC service.
Do not turn the power OFF during
the one-touch call.
Do not turn the power OFF until the
automatic alarm notification ends.
Connecting with NC service.
Wait for communication to end.
Connecting with machine
manufacturer.
Wait for communication to end.
search engine
5. Diagnosis Screens
I – 299
Details
• Communication has not been
started.
• A call is being placed with
automatic alarm notification or
one-touch call, and a call is being
received from the NC service.
Details
• A call is being placed with the
automatic alarm notification.
• Communication starts when an
alarm occurs, but the line is not
connected yet in this state.
• This state is also entered when
standing by for transmission.
• The line is connected with
automatic alarm notification.
• The diagnosis data is being sent
with automatic alarm notification.
• Communication has been started
with emergency stop by the servo,
spindle or PLC alarm, or by the
establishment of the conditions
set in the parameters.
• Automatic alarm notification has
ended, and the line has been
disconnected.
• Redialing since the NC service is
using the line for other
communication.
• In connection standby state since
line is being used by anshin-net.
• In connection standby state since
line is being used by machine
network.