Mitsubishi Electric MELDAS 600M Series Instruction Manual page 122

#
320019 Initial G00
320020 Auto restart
320021 Drilling Z fixed
320022 Fixed cycle
320023
320024
320025
320026
320027 Tool select
320028 Initial high
320029 Playback G90
320030 Interrupt amt
Downloaded from ManualsNet.com
CHAPTER 1 SCREEN OPERATIONS
2. Monitor (Operation) Screens
Item Setting
ON
OFF
ON
valid
OFF
ON
OFF
ON
modal
OFF
T leng offset Z ON
fix
OFF
Syncronized ON
tapping
OFF
T-life manage ON
valid
OFF
Tool command ON
mthd 2
(When tool life
OFF
management is
valid)
ON
mthd 2
(When tool life OFF
management is
valid)
ON
precis
OFF
ON
OFF
ON
reset
OFF
search engine
G00 (positioning) mode is the initial state when the power is
turned ON.
G01 (linear interpolation) mode is the initial state when the
power is turned ON.
The restart position is automatically moved to at the first start
when the program is restarted.
The program is restarted after moving to the restart position
with manual operations.
The fixed cycle drilling axis is fixed to the Z axis.
The fixed cycle drilling axis is an axes in a plane other than that
designated with G17 to G19.
During the fixed cycle mode, movement to the drilling position
follows the NC unit modal state (G0, G1).
During the fixed cycle mode, the axis is positioned to the drilling
position with G00.
The offset axis during tool length offset is fixed to the Z axis.
The offset axis during tool length offset is designated with the
program.
The G74, G84 tap cycle is a floating tap chuckless tap cycle.
The G74, G84 tap cycle is a tape cycle with floating tap chuck.
The tool life management is controlled.
The tool life control data is ignored.
The program tool command is handled as a tool No.
The program tool command is handled as a group No.
The tool with the maximum remaining life is selected from the
tools used or not used within the same group.
The tools are selected in registered No. order from the tools
used in the same group.
The G61.1 (high-precision control) mode is the initial state
when the power is turned ON.
The G64 (cutting) mode is the initial state when the power is
turned ON.
The machining program created with playback is created with
absolute values.
The machining program created with playback is created with
incremental values.
By pressing the reset button, the amount interrupted with
manual or handle feed (when manual ABS is OFF) is cleared to
zero. (The coordinates deviated by the interruption are
returned to the original values.)
Even if the reset button is pressed, the amount interrupted with
manual or handle feed (when manual ABS is OFF) is held.
(The coordinates deviated by the interruption are held.)
I – 107
Details