Toshiba GR200 Series Instruction Manual page 901

command is not identical to "IED test status".
Note: The "Event suppression" function can detect chattering in BI circuits. (See section
6
4.8.6(i)-3)
Note: A supervision of the Binary IO module can detect connection errors for BI circuits.
7
Note: The Common control (CMNCTRL) function can test and check the operation-
8
direction of logic. When the user sets Off for scheme switch [SCDEN], operation of
the logic is blocked if the logic is running in the same operation-direction
compared with the previous operation-direction. Alternatively, if On is set for the
scheme switch, the logic is not blocked.
Note: The user must program the PLC logic "Control hierarchy condition". The user
9
must connect the "Control hierarchy condition" to the select condition logic using
the connection point "DPOS01IN_TMP_28". For more information, see Chapter
Control and monitoring application: Control hierarchy
4.8-7.Note that the logic outputs are generated separately for both On and Off.
Signal name and number
(viii)
Note: The user should note the meaning of the following descriptions as shown in
column "M/O" of each table:
"O" indicates that the signal is provided for optional use.
"M" indicated that the user should map/set/configure the signal; otherwise, the
"N/A" indicates that that the user cannot change the state of the signal.
Table 4.8-14 PLC connection points (Input point for PLC#1 User configurable condition)
Signal Number Signal Name
512001 810301EE57 DPOS01IN_TMP_35
512001 810302EE57 DPOS01IN_TMP_35
512001 810303EE57 DPOS01IN_TMP_35
.... ....
512001 810348EE57 DPOS72IN_TMP_35
Table 4.8-15 PLC connection points (Input point for PLC#2 User configurable condition)
Signal Number Signal Name
512001 820301EE5E DPOS01IN_TMP_42
512001 820302EE5E DPOS02IN_TMP_42
512001 820303EE5E DPOS03IN_TMP_42
... ...
512001 820348EE5E DPOS72IN_TMP_42
Table 4.8-16 PLC connection points (Input point for PLC#3 User configurable condition)
Signal Number Signal Name
512001 800301EE53 DPOS01IN_TMP_34
user experience an operational failure if the default settings are used.
Description
DPOS01 user configurable condition(PLC#1)
DPOS02 user configurable condition(PLC#1)
DPOS03 user configurable condition(PLC#1)
.....
DPOS72 user configurable condition(PLC#1)
Description
DPOS01 user configurable condition(PLC#2)
DPOS02 user configurable condition(PLC#2)
DPOS03 user configurable condition(PLC#2)
...
DPOS72 user configurable condition(PLC#2)
Description
DPOS01 user configurable condition(PLC#3)
- 878 -
6F2S1914 (0.49)
. See PLC#3 of Table
M/O
O
O
O
O
M/O
O
O
O
O
M/O
O
GRL200 (Soft 033 & 037)