Toshiba GR200 Series Instruction Manual page 596

ASEQ
User's PLC
PLC monitoring point
Figure 3.5-2 Example of user-preferred control scheme using PLC user logic
Note: The user-preferred control scheme implemented by users can only be operated in
the DIR mode.
Signal for Local/Remote control
3.5.4
Note: The following references are used in the column "M/O" in Table 3.5-3 and Table
3.5-4:
"O" means the signal is optional.
"M" means the user should map/set/configure the signal; otherwise, the user
"N/A" means that the user cannot change the state of the signal.
Table 3.5-3 PLC connection point (Input point for LOCRMT)
Signal Number Signal Name
240001 31000A1735 L/R CHG
530001 800901EDE0 LRSW01_PLC_SGN01
530001 800901EDE1 LRSW01_PLC_SGN02
Signal Number Signal Name
530001 3009011008 LRSW01_LR_ORCAT
530001 6A09011009 LRSW01_LR_ORIDENT
Signal Number Signal Name
530001 3109001001 LRSW01_LR_ST
530001 3009011001 LRSW01_LR_ST_RMT
SPOS
logic
may experience an operational failure if the default settings are used.
Description
[L/R] key "push"
Disable condition by PLC
User configurable condition by PLC
Table 3.5-4 Mapping points for LOCRMT
Description
Mapping data for "originator" in IEC61850
Mapping data for "originator" in IEC61850
Table 3.5-5 PLC monitoring point (LOCRMT)
- 573 -
User's PLC
logic
PLC connection point
Description
Local(T) / Remote(F) status (single bit expression)
Local(0x40) / Remote(0x80) status (double bit expression)
6F2S1914 (0.49)
DPOS
M/O
N/A
O
O
M/O
N/A
N/A
GRL200 (Soft 033 & 037)