Toshiba GR200 Series Instruction Manual page 645

Receiving "select command Off" from the remote-end
(ii)
Figure 4.1-3 outlines the reception of the select command 'Off ' from the remote- end.
Wait for a command
Select stage
Select command On from remote-end
Select command Off from remote-end
Signal reception
IEC61850
Select command On from front panel
Select command Off from front panel
Select command On by the PLC
Select command Off by the PLC
Input point required mapping
Figure 4.1-4 shows the select logic when a "Select command Off (Remote-OFF-Control)" signal
is received at the input-point "DEV01_CONTROL_REQ".
Input
Command "Remote-Off-Control"
510001_7001016D08
DEV01_CONTROL_REQ
ILK† condition ("Off") passed
Either "SBO mode" or "DIR mode"
(e.g., "ctlmodel" in IEC61850*)
"Automatic sequence control function (AQEQ)§" in progress
ASEQ_MULTI_SEL
Figure 4.1-4 Select 'OFF' from the remote-end in SPOS01
†Note: The ILK function provides the operation criteria for "Off".
‡Note: The "select condition" signal is provided. See Figure 4.1-13.
Note: To identify the input and output points of the other SPOS logics, see Table 4.1-5
††
and Table 4.1-9.
Selection logic
Figure 4.1-3 Outline of select command 'Off'
SPOS01 function (Function ID: 510001)
For SBO operation
Select command
with ILK† condition
For DIR operation
Operate command
with ILK† condition
SPOS01-Off
For SBO operation
Select command
without ILK† condition
For DIR operation
Operate command
without ILK† condition
In SBO operate
In DIR operate
Select condition‡
Failed
Select
Signal output
decision
Success
Selection logic in SPOS01
&
&
&
&
- 622 -
6F2S1914 (0.49)
Wait for a next command
Cancel logic
Cancel command
Cancel logic
Operate logic
Operate command
Operate logic
1≥
&
To BO connection
"SPOS01_FSL_BO_CSF"
(510001_8A01011DC4)
0
t
Selection "success"
0.1s
To "Wait for a command"
0 t
0.6s
††
GRL200 (Soft 033 & 037)
Output
Selection "Failed"