Toshiba GR200 Series Instruction Manual page 183

ZS (Function ID： 430001）
Setting items
Z1XS-
MhoR.EN
Z1XS-R.Angle
Z1XS-R.Reach
Z1XS-
MhoDX.EN
Z1XS-DX.Angle
Quad
Z1XS-X.Reach
Z1XS-
X.GrAngleEN
Z1XS-R.Angle
Z1XS-R.Reach
Z1XS-DX.Angle
Z1XS-DR.Angle
TZ1XS
Z1XS-CovCoeff
Output
Z1XS-MSDET
Z1XS-PSBBlk
Z1XS-LEBlk
Z1XS-ARCBlk
Z1XS-OCFS-
EN
OCF1XS
Z1XS-SOTF
Note 1: On-Adapt is only applicable when Forward is set for ZS.
Note 2: When On-Adapt is set for the scheme switch [Z*S-X.GrAngleEN], the setting
value [ZSF-X.GrAngle1] will be calculated by itself. However, the user should
enter a value for [ZSF-X.GrAngle2] regardless of the setting of the [ZS-
X.GrAngleEN].
Range
Unit
1A rating 5A rating
Off / On - Z1XS resistive reach use or not (for Mho)
30 - 90 deg Z1XS resistive reach characteristic angle
0.10 - 0.01 -
- Z1XS resistive reach
500.00 100.00
Z1XS directional-X characteristic use or not
Off / On -
(for Mho)
0 - 60 deg Z1XS directional-X characteristic angle
0.10 - 0.01 -
- Z1XS reactance reach
500.00 100.00
Off / On-Set / On-
- ZS gradient characteristic
Adapt
30 - 90 deg Z1XS resistive reach characteristic angle
0.10 - 0.01 -
- Z1XS resistive reach
500.00 100.00
0 - 60 deg Z1XS directional-X characteristic angle
Z1XS directional-R characteristic angle (for
0 - 60 deg
Quad)
0.00 - 100.00 s Z1XS operation delay time
1.5 - 10.0 - Covered characteristic size coefficient
Multi-phase or non-earth-fault condition is
Off / On -
used or not
Non / Block - Z1XS operation block or not by PSB detection
Non / Block - Z1XS blocked or not by Load encroachment
Non / Block - Autoreclose execution block by Z1XS-trip
Off / On - Fail-safe OC for Z1XS-trip
0.10 -
0.02 - 5.00 A Fail-safe OC operation level for Z1XS-trip
25.00
Off / On - SOTF using Z1XS
160
6F2S1914 (0.49)
Contents
GRL200 (Soft 033 & 037)
Default
Note
1A 5A
Off
75
25.50 5.10
Off
30
12.00 2.40
Off
75
25.50 5.10
30
5
0.00
1.5
On
Block
Non
Non
Off
0.20 1.00
Off