Toshiba GR200 Series Instruction Manual page 793

Line differential protection ied

Hide thumbs Also See for GR200 Series:

Table of Contents

‡Note: The measurements in the DPOS and the DPSY functions are grouped into four

intervals in each respective device. Measurement is possible by sensing the device

events. The measured intervals are accumulated; they are grouped into four

intervals (OT1–OT4), which the user can monitor from the IED screen. Figure

4.4-2 and Figure 4.4-3 exemplify the four intervals upon occurrence of On

(Closing)-control event and Off (Open)-control event, provided that the DPOS

function operates.

Issuing Off control

intermediate state

Device status for "Off"

Figure 4.4-2 Two intervals (OT1 and OT2) for Off-control event

Issuing On control

intermediate state

Device status for "On"

Figure 4.4-3 Two intervals (OT3 and OT4) for On-control event

Tips: If the user wishes to implement the OPTIM function quickly, go to section 4.4.4,

which discusses how to map signal-points for the IEC 61850 communication.

─────────────────────────────────────────────────────────────────

The implementation of such features depends on the selection of hardware and the

configuration of functions. Several IED models do not have its features. To determine whether

its features are implemented in the IED, locate the IED ordering number; and check the order

number at the "G&T position" referring to the comparison table below. For more information,

Appendix: Ordering

Table 4.4-1 Comparative table in respective ordering numbers

✓: Applicable

Main features

NA: Not applicable

Intermediate

Intermediate

Ordering No. at "G&T"

6F2S1914 (0.49)

GRL200 (Soft 033 & 037)

Chapters

Table of Contents