Toshiba GR200 Series Instruction Manual page 623

Wait for a command
Select stage
Select command
Reset from the
remote-end
Figure 3.7-12 Outline of Operate command 'Reset'
New counter value
Figure 3.7-13 shows that the user can set a new value for the counter using the statics sub-
menu†. The new value is applied into "Statics counter" point in Figure 3.7-11.
Figure 3.7-13 Counter menu in the statics sub-menu
†Note: For the operation, see
Output signal to BO
The GCNT01 function can provide a signal at the point "GCNT01_OK_CSC", when the new
value applied from the sub-menu is appropriate.
Wait for a next command
Operate command Reset from the remote-end
Operate logic
Signal reception
in the IEC61850
Operate command Reset from the local-end
Operate logic
Signal reception
from
the front panel
Counter
10:48
COUNT1 (No Assign)
COUNT2 (No Assign)
0
COUNT3 (No Assign)
Chapter User interface: Monitoring sub-menu
- 600 -
Success
Operation
decision
Failed
Success
Operation
decision
Failed
1/8
+
0
+
+
0
6F2S1914 (0.49)
Signal output
Do nothing
Signal output
Do nothing
.
GRL200 (Soft 033 & 037)