Toshiba GR200 Series Instruction Manual page 886

Signal name and number
(iv)
Note: The user should note the following descriptions shown in the column "M/O" for
each table:
"O" indicates that the signal is provided for the optional use.
"M" indicates that the user should map/set/configure using the signal;
"N/A" indicates that the user cannot change the state of the signal.
Table 4.8-11 PLC connection points (Input signal for 'cancel' condition logic)
Signal Number
512001 800301EE69
512001 800302EE69
512001 800303EE69
...
512001 800348EE69
Table 4.8-12 PLC monitoring points (Output signal for 'cancel' condition)
Signal Number
512001 8603011E95
512001 8603021E95
512001 8603031E95
...
512001 8603481E95
512001 8703011E96
512001 8703021E96
512001 8703031E96
....
512001 8703481E96
Setting name
(v)
Note: The "xx" within "DPOSxx" represents the DPOS function number. (e.g., if
DPOS03 is considered, the "xx" is equal to "03". The numbers used for "xx" can be
represented by "01" to "72".)
Setting Name
DPOSxx-LGCNFFCT
otherwise, the user may experience an operational failure if the default
settings are used.
Signal Name Description
DPOS01IN_TMP_44 DPOS01 user configurable cancel condition
DPOS02IN_TMP_44 DPOS02 user configurable cancel condition
DPOS03IN_TMP_44 DPOS03 user configurable cancel condition
... ...
DPOS72IN_TMP_44 DPOS72 user configurable cancel condition
Signal Name Description
DPOS01_CC_SS DPOS01 cancel success
DPOS02_CC_SS DPOS02 cancel success
DPOS03_CC_SS DPOS03 cancel success
... ...
DPOS72_CC_SS DPOS72 cancel success
DPOS01_CC_FS DPOS01 cancel failed
DPOS02_CC_FS DPOS02 cancel failed
DPOS03_CC_FS DPOS03 cancel failed
... ...
DPOS72_CC_FS DPOS72 cancel failed
Table 4.8-13 Setting for 'Cancel' in DPOSxx
Description
Logic selector for cancel condition in DPOSxx
- 863 -
6F2S1914 (0.49)
Default Setting item or value
Fixedlogic Fixedlogic / PLC
GRL200 (Soft 033 & 037)
M/O
O
O
O
O
O