Toshiba GR200 Series Instruction Manual page 622

Operate logic for SBO/DIR modes
3.7.4
After the operation of the select logic, the operate logic starts to clear the counters.
Receiving "Operate command Reset" from the remote-end
(i)
Figure 3.7-10 depicts the reception of the operate command 'Reset' from the remote-end.
Wait for a command
Select stage
Select command
Reset from the
remote-end
Figure 3.7-10 Outline of Operate command 'Reset'
Mapping required for Input point
Figure 3.7-11 illustrates the operation logic when an "Operate command Reset (Remote-Reset-
Control)" signal is applied to the GCNT01 function. The input-point "GCNT01_CMM_REQ" is
used for the reception of the "Operate command Reset (Remote-Reset-Control)".
Output signal to BO
The GCNT01 function, in Figure 3.7-11, can provide a signal at the point "GCNT01_OK_CSC",
when the GCNT01 function determines that the signal "Remote-Reset-Control" is true.
Input
Command "Remote-Reset-Control"
540001 700E016D09
ASEQ function§" is in progress
Figure 3.7-11 Operate 'On' from the remote-end
§Note: The ASEQ function can provide sequential signals for automatic control.
Note: To identify the input and output signal-points of the GCNT02–32 logics, see Table
††
3.7-2 for the mapping points, Table 3.7-9 for the outputs.
Receiving "Operate command Reset" from the local-end
(ii)
Figure 3.7-12 depicts the reception of the operate command 'Reset' from the local-end.
Wait for a next command
Operate command Reset from the remote-end
Operate logic
Signal reception
in the IEC61850
Operate command Reset from the local-end
Operate logic
Signal reception
from
the front panel
GCNT01 function (Function ID: 540001)
Operate Cmd.
GCNT01_CMM_REQ
Operate condition‡
ASEQ_MULTI_SEL
Statics-counter
- 599 -
Operation
decision
Failed
Operation
decision
Failed
Operate logic in GCNT01
1≥
&
6F2S1914 (0.49)
Success
Signal output
Do nothing
Success
Signal output
Do nothing
Output
"
GCNT01_EC_OK_CSC"
(540001 820E011E84)
††
GRL200 (Soft 033 & 037)