Toshiba GR200 Series Instruction Manual page 800

Mapping for IEC61850 communication
4.4.4
The user can operate the OPTIM function over the IEC61850 communication after the
mapping using the GR-TIEMS. Note that the OPTIM function is designed for "Single Point
Controller (SPC) class" in the IEC61850 communication. The user should follow steps:
Step1: Editing Logical Node
Step2: Mapping output data
Step3: Mapping input data
Editing Logical Node
(i)
The user should make a logical node (LN) for the OPTIM function. Figure 4.4-12 exemplifies
LN editing; the LN "General Input / Output (GGIO)" is chosen for the OPTIM function. After
the user defining an object "SPCSO", the OPTIM logical node can be saved with the name
"GIGO" plus "LN Instance". Make a definition of the object "SPCSO" in the OPTIM logical node.
"Either the SBO mode or the DIR mode can be chosen in the LN editing.
Figure 4.4-12 Defining "SPCSO" object in GIGO3302 logic node
SBO defined in LN
- 777 -
6F2S1914 (0.49)
GRL200 (Soft 033 & 037)