Toshiba GR200 Series Instruction Manual page 647

Input
Command "Local-On-Control"
ILK† condition ("ON") passed
ILK† bypassing ("Interlock Bypass")
Either "SBO mode" or "DIR mode"
(e.g., "ctlmodel" in IEC61850*)
"Automatic sequence control function (AQEQ)§" in progress
ASEQ_MULTI_SEL
Figure 4.1-6 Select 'On' on the front panel in SPOS01
†Note: The ILK function provides the operation criteria for "On". For testing, nullifying
the ILK function is possible using "Interlock bypassing". "Interlock bypassing" is
indicated by the status "ICB" in a software switch controller (SOFTSW).
‡Note: A "select condition" signal is provided from the select condition scheme. For more
information, see Figure 4.1-13.
§Note: An Automatic sequence control (ASEQ) function can provide sequential signals for
automatic control. The SPOS01 operation is blocked for the ASEQ function when
it is in operation. For more information regarding the ASEQ function, see Chapter
Control and monitoring application: Automatic sequence control function
Note: To identify the output signals of the other SPOS logic, see Table 4.1-9.
††
Output signal to BO
When the "select condition" signal is true, the SPOS01 function can issue a "Selection success"
signal at the output-point "SPOS01_OSL_BO_CSF".
Note: The signal "SPOS01_OSL_BO_CSF" is the same as the signal shown in Figure
4.1-2. If the "Local-ON-Control" signal is not true, the SPOS01 function returns to
the "Wait for a command" stage.
SPOS01 function (Function ID: 510001)
For SBO operation
Select command
with ILK† condition
For DIR operation
Operate command
with ILK† condition
SPOS01-On
1≥
ICB_STATE
[SPOS01-CTRAHMI]
SBO
Select condition‡
Select logic in SPOS01
&
SBO
&
DIR
- 624 -
6F2S1914 (0.49)
1≥
&
To "Wait for a next
To BO connection
"SPOS01_OSL_BO_CSF"
(510001_8601011DC6)
0
t
Selection "success"
0.1s
To "Wait for a command"
0 t
Selection "Failed"
0.6s
††
GRL200 (Soft 033 & 037)
Output
command"
.