Toshiba GR200 Series Instruction Manual page 174

Line differential protection ied

Hide thumbs Also See for GR200 Series:

Table of Contents

by using only the reach settings, the user may be required to set the TZ3

Setting for backward lines (Zones4 and 5 serviced as backup relays)

If backward adjacent lines are required to protect by the relay

suitable to protect. For example, as shown in Figure 2.10-53, if setting the reach of the zone4

can be performed in the reverse to cover the busbar and the transformer, the zone4

operate as a back-up relays.

Extra setting for the primary zone (Zone1X with autoreclosing)

The user should notice that disadvantages exist in the CTI schemes, because a fault occurred

a bit beyond the zone1 may be cleared in delay by the zone2. That is, the zone1 plus the zone2

cannot clear speedily for any fault on the line AB†. Thus, the extra zone1 (zone1X) is designed

to clear the fault occurred near the busbar B; its operation is taken together with the operation

of the autoreclose function (ARC‡).

Figure 2.10-56 CTIs for zone1 and zone1X

As shown in Figure 2.10-56, the reach of the zone1X should be set to overreach the

protected line AB. Once a fault occurs near busbar B, the ARC function must operate to follow

the TRIP COMMAND issued by the zone1X. The user must know that the zone1X is just

effective about the transient fault for which the ARC operation§ can recover the power

transmission.

If evolving faults occur, the zone1X will issue one-more TRIP COMMAND successively to

follow a CB reclose command issued by the ARC function. If the permanent fault occurs, the

zone1X will issue no TRIP COMMAND respond to a reclose-on-to-fault condition.

†Note: The command distance protection (DISCAR) is provided for the speedy protection

6F2S1914 (0.49)

longer than the

or the zone5

GRL200 (Soft 033 & 037)

Chapters

Table of Contents