Fujitsu ETERNUS DX80 S2 Cli User's Manual page 113

Chapter 3 Configuration Settings and Display
3.3 RAID Group Management > create raid-group
-stripe-depth
■
Example(s)
The following example creates a RAID group named "RGP001". RAID1 level is assigned using disks #003 and
#004:
CLI> create raid-group -name RGP001 -level 1 -disks 003,004
For the ETERNUS DX8700 S2:
cm0cpu0 Controller module#0 CPU#0
cm0cpu1 Controller module#0 CPU#1
cm1cpu0 Controller module#1 CPU#0
cm1cpu1 Controller module#1 CPU#1
cm2cpu0 Controller module#2 CPU#0
cm2cpu1 Controller module#2 CPU#1
cm3cpu0 Controller module#3 CPU#0
cm3cpu1 Controller module#3 CPU#1
cm4cpu0 Controller module#4 CPU#0
cm4cpu1 Controller module#4 CPU#1
cm5cpu0 Controller module#5 CPU#0
cm5cpu1 Controller module#5 CPU#1
cm6cpu0 Controller module#6 CPU#0
cm6cpu1 Controller module#6 CPU#1
cm7cpu0 Controller module#7 CPU#0
cm7cpu1 Controller module#7 CPU#1
auto Automatically (default)
Optional. This parameter specifies the stripe depth for the RAID group that is to be created. If
omitted, then it is handled as if "64kb" is selected. The available values vary depending on the
RAID level and the number of drives.
64kb 64k Byte
128kb 128k Byte (Only for RAID 5 configurations of 10 or more disks, RAID 0
configurations, and RAID1+0 configurations)
256kb 256k Byte (Only for RAID 5 configurations of 9 or less disks, RAID 0
configurations, and RAID1+0 configurations)
512kb 512k Byte (Only for RAID 5 configurations of 5 or less disks, RAID 0
configurations, and RAID1+0 configurations)
1024kb 1024k Byte (Only for RAID0 configurations and RAID1+0 configurations)
ETERNUS CLI User's Guide
Copyright 2015 FUJITSU LIMITED
113
P2X0-1030-09ENZ0